Presettings
Operating instructions GLP
3 -- 85
6.562.98.5.01.18
Indicating the mean value of the preset number of packages
After activation and check of the preset number of packages, the indicator
xx
shows their mean value on the weight scale located above it. The input of the re-
levant number of packages is described on the next page. Value xx in the indica-
tor = preset number of packages.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Labe--
ling
Weight cl.
statist.
Statist.
display
Analog
display
Call up the selection menu
MeanVal.
n pckg.
Disp.
W/o
Set the devioce to ’Disp.’ if the mean value of the preset number
of packages is to be displayed on the weight scale.
Standard setting: W/o
xx
Presetting the number of packages for checking the mean value
If the display ’Mean value n packages’ is activated (see above), the relevant
number of packages may be preset here (2 -- 99 packages).
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Labe--
ling
Weight cl.
statist.
Statist.
display
Analog
display
MeanVal.
... packg.
Call up the
input menu.
x x [ENTER] -- Preset the number of packages for the mean value check.
Description of display symbols within TU2 -- TO2
1
Current weight of the weighed package
∅
∅∅
∅
Mean value of all checked packages
xx
Mean value of the preset number of packages
Description of display symbols outside TU2 and TO2
1
Current weight above the visible range (> TO2)
1
Current weight below the visible range (< TU2)
Because of the fact that several indicators may be activated at the same time, the
following priority has been determined for the event that indicators overlap:
Highest priority
xx
-->
∅
∅∅
∅
-->
1
lowest priority.
3
To Next Page
Loading...
