Presettings
Operating instructions GLP
3 -- 102
6.562.98.5.01.18
Description of the possible settings for the print channel
setting
For channels Intern and A -- G the following settings are possible in each case:
always active
not active
active when special price
not active when special price
Pair 1 (start) change on paper end
Pair 1 (Standby) change on paper end
Pair 2 (start) change on paper end
Pair 2 (Standby) change on paper end
Pair 3 (start) change on paper end
Pair 3 (Standby) change on paper end
Pair 1 (start) alternated after each package
Pair 1 (Standby) alternated after each package
Pair 2 (start) alternated after each package
Pair 2 (Standby) alternated after each package
Pair 3 (start) alternated after each package
Pair 3 (Standby) alternated after each package
Through pair generation in the case of double or multiple labelers you can specify which
labelers belong together and which begins from both (start) and which waits for the relevant
event (standby). Through pair generation up to 6 labelers in 3 pairs per 2 labelers can be
combined.
Example setting:
Set e.g. for channel A (1st. labeler): ”Pair 1 (start) change at paper end
Set e.g. for channel B (2nd. labeler): ”Pair 1 (standby) change at paper end
Labeler 1 on channel A prints labels until message ”paper end” comes. Then there
is an automatic switch to labeler 2 on channel B, which then prints the labelers.
3
To Next Page
