Presettings
Operating instructions GLP
3 -- 114
6.562.98.5.01.18
3.6.1.5 Preselecting type total 3
The type total necessary for total 3 may be entered here.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Config.
total
Preselect
total
Preselect
type tot3
-- Call up the selection menu.
Preselect
pieces
Make this setting if the total to be labeled is to be preset as a piece
total.
Preselect
weight
Make this setting if the the total to be labeled is to be preset as a
weight total (setting for example).
Preselect
price
Make this setting if the total to be labeled is to be preset as a price
total.
Number of
totals 1
Make this setting if the total to be labeled is to be the number of the
reached totals 1 (setting used for the example).
Number of
totals 2
Make this setting if the total to be labeled is to be the number of the
reached totals 2 (setting used for the example).
Pres.pcs
viaSiNum
Make this setting if the appearance of the message ’Total 3 re-
ached’ is needed for the operator on reaching the preset end total
of the single numerator.
Note: when selecting this presetting, delete ’With *3’ should be set
for the single numerator at mode level 5.
Second.
price
Make this setting if the secondary price total is preset as the total
to be labeled.
3.6.1.6 Presetting total 3*
This menu point serves to enter the total necessary for total 3 in the previously
selected total type, e. g. number *2 in *3 (see ”Preselecting type total 3”).
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Config.
total
Preselect
total
Number
*2 in *3
-- Call up the input menu.
xx [ENTER] , [ETC] --Enter total 3 according to the preset total type, e. g. ”Number
*2 in *3” and acknowledge or save in database
(see page
1 -- 32)
.
3
To Next Page
Loading...
