Presettings
Operating instructions GLP
3 -- 142
6.562.98.5.01.18
3.7.5 Printer menu
3.7.5.1 Print rate
The standard setting for the print rate is130 mm/second. The minimum print
speed which can be set is 30 mm/second and the maximum print rate170 mm/se-
cond (with a 7,5--dot thermal strip). In the event that the print quality is insufficient,
a different print rate may be entered or there is the possibility of changing the print
rate via the PLU data.
Input range: 30 to 170. If the value entered exceeds the range, an er-
ror message appears and the range is displayed!
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Labels Printer
menu
Print
speed
-- Call up the input menu.
xxx [ENTER] /,[ETC] -- Enter the new value and acknowledge or save
in data-
base (see page 1 -- 32).
3.7.5.2 Paper grade
This setting cannot be made on the GLP.
3
To Next Page
Loading...
