Bizerba GLP 80 - Page 281

Presettings
Operating instructions GLP
3 -- 143
6.562.98.5.01.18
3.7.5.3 Setting density for thermal labels
The print voltage for thermal printing may be changed over a given range. This
range is preset by the printer electronics in relation to the dot bar built--in. The va-
lue is entered in percent which causes an appropriate percentage change of the
value determined.
Input range: --20 to 5. If the value entered exceeds the range, an error
message appears and the range is displayed!
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Labels Printer
menu
Saturat.
DT
-- Call up the input menu.
[ +/-- ] -- Enter the minus sign for a negative percentage value.
xx [ENTER] -- Enter the percentage value and acknowledge.
3.7.5.4 Set density for thermal transfer labels
The print voltage for thermal transfer printing may be changed over a given range
preset by the printer electronics in relation to the dot bar built--in. This permits the
print quality to be influenced up to a certain extent. The value is entered in percent
which causes an appropriate percentage change of the value determined.
Input range: --20 to 5. If the value entered exceeds the range, an error
message appears and the range is displayed!
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Labels Printer
menu
Saturation
TTF
-- Call up the input menu.
[+/--] -- Enter the minus sign for a negative percentage value.
xx [ENTER] -- Enter the percentage value and acknowledge.
3.7.5.5 Retract operation
During retract operation the label is pulled back by approx. 10 mm. This is neces-
sary:
-- for Linerless labels
-- if the first 10 mm on the label are to be printed with variable data
-- for labels on the label roll being turned by 180 degrees and on which the first
10 mm are to be printed
Depending on the label type the retract operation may also be pre-
set under label parameter (see programming instructions)!
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Labels Printer
menu
-- Call up the selection menu.
Retract
-- +
mode
Preselect ’W/o’(--) or ’With(+)’ retract operation.
Standard: without
3