Presettings
Operating instructions GLP
3 -- 148
6.562.98.5.01.18
3.8 Printer and interface settings
3.8.1 Send channels active
The send channels for customer--provided equipment may be activated or deacti-
vated as required, permitting, for example, to deselect an EDP connection in the
event of malfunction or other problems. The labeler may then be operated inde-
pendently. The channel which is to be activated or deactivated should always be
checked.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Printer&
intrface
Send ch.
active?
-- Call up the selection menu.
Send
chan. A
+
--
Activate or deactivate the relevant send channel, e. g. A.
(--) = off, (+) = on
Internal printing
If all labels are to be printed on a printer connected, the internal printer may be
deactivated
(as regards twin labelers, all labels may, for example, be printed on the second
labeler).
Internal
printing
+
--
Preselect ”internal printing yes(+) or no(--)”.
Standard: internal
3.8.2 Print channel control
The presettings for the print channel control are already described in chap. 3.5.5
from page 3 -- 101 onward
3.8.3 List printer
.
The list printer may only be operated on the labeler with the
licence ”LINE_PRINTER” activated.
3.8.3.1 List number
If a list printer is connected to the labeling system, the list type to be printed may
be selected by entering a list number. All lists and the list printer are described in
section 5.5.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Printer&
intrface
List
printer
List
number
-- Call up the input menu.
xx [ENTER] -- Enter the list number and acknowledge.
3
To Next Page
Loading...
