Bizerba GLP 80 - Page 287

Presettings
Operating instructions GLP
3 -- 149
6.562.98.5.01.18
3.8.3.2 Database list number
If a list is to be printed containing all articles labeled per customer, the relevant
database list number may be entered here.
After input of the list number for the database list, printing of the
list must be started separately.
Operating sequence: Description
[MODE] 2 [ETC]
Printer&
intrface
List
printer
DB list
number
-- Call up the input menu.
xx [ENTER] -- Enter the list number and acknowledge.
3.8.3.3 Print out DB list
Operating sequence: Description
[MODE] 2
Printer&
intrface
List
printer
DB list
number
Print
DB list
-- Database list printing
3.8.3.4 Printing rerouting to determine service printouts
Here it may be preset where the service printouts defined in mode level 5 are to
be printed or displayed.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Printer +
interface
List
printer
Deviat.print
service pr.
-- Call up the selection menu.
Label
printer
Make this setting if the service printouts are to be printed on the
standard label printer. (Default setting).
List print.
interf.
Make this setting if the service printouts are to be printed on a con-
nected list printer.
Only
e--service
Make this setting if the service printouts are directly to be displayed
on a PC or laptop via an Ethernet interface or sent to the BIZERBA
service to be displayed.
3