Presettings
Operating instructions GLP
3 -- 160
6.562.98.5.01.18
3.9 Numerators
Whether or not a consecutive number is to be printed on single or total labels of
total 1 -- 3 and how the relevant numerators are to be cleared is set at mode
level 5. All numerators not activated at mode level 5 are presented in grey at
mode level 2.
Each numerator activated may be preset to any value at the beginning.
There is also the possibility of entering a range of values with a start and an end
value for each numerator. This permits the following numerator functions to be
carried out:
Example A:
Count up to the value preset and restarting at the beginning
-- Enter the higher end value as the start value.
The numerator counts from the start value forward up to the end value. After the
end value is reached, the counting procedure restarts with the start value.
Example: 10 packages of a carton (box) are to be numbered from 1 to 10
and then counting is to be restarted from the beginning.
Example B:
Counting backward from the value preset and restarting at the beginning
-- Enter the higher start value as the end value.
The numerator counts backward from the higher start value up to the end value.
After the end value is reached, the counting procedure restarts with the start value.
Example:
The number appearing on the label or the display indicates the
number of packages which is still to be labeledfor a pack or thelike.
3.9.1 Single numerator
A single numerator may be preset to any value at the beginning.
.
If you want to see the current status of he numerator, close the
display by pressing key [ESC] or [HOME]!
Do not preset a single numerator if the operating mode ”..piece no. PLU
total” is preselected at mode level 5 or if a range of values is preset (see
section 3.9.2).
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Numer--
ators
Single
numerat.
-- Call up the input menu.
xx [ENTER]
--
Enter the value and acknowledge.
The number is printed on the next single label.
3
To Next Page
Loading...
