Bizerba GLP 80 - Page 299

Presettings
Operating instructions GLP
3 -- 161
6.562.98.5.01.18
3.9.2 Value range of single numerator
See description on page 3 -- 160.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Numer--
ators
Val.range
single num.
-- Call up the input menu.
xx -- Enter the start value, e. g. 1 (see example A).
Val.range single num.: Start
_1
99999999
Cancel <ESC>
OK <ENTER>
Val.range single num.: End
[ENTER] -- Acknowledge input.
The system moves automatically to the end--entry.
xx -- Enter the end value, e. g. 10 (see example A).
1
_10
Cancel <ESC>
OK <ENTER>
Val.range single num.: Start
Val.range single num.: End
[ENTER] [ENTER] -- Acknowledge input and exit the input menu.
[ ] , [ ] The start or end input field may be directly selected using the
cursor keys.
3.9.3 Total1, total2 or total3 numerator
The numerators for totals 1 -- 3 may be preset to any value.
.
If you want to see the current status of he numerator, close the
display by pressing key [ESC] or [HOME]!
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Numer--
ators
-- Call up the input menu.
Total 1
numerat.
xx [ENTER]-- preset the numerator of total 1.
Total 2
numerat.
xx [ENTER] -- preset the numerator of total 2.
[ETC]
Total 3
numerat.
xx [ENTER] -- preset the numerator of total 3.
3