28
Enable Static Recording
Press and hold down the button for two seconds to
enter the static recording mode. The display should indicate
“MAX AVG MIN” simultaneously. This indicates the meter is
in static recording mode and recording is performed
immediately.
Using Static Recording
There are four different modes that can be selected in
static recording. They are indicated by the
descriptions below. These modes can be changed
with each button press. Per each press of the
button, the modes will change and repeat in
the following order:
Recording Mode Maximum Mode Minimum
Mode Average Mode
Recording Mode
This is the default mode when first enabling static
recording. In this mode, the screen will display “MAX
AVG MIN” indicator. At this point, the meter will start
making recordings based on measured values from
To Next Page
Loading...
Need help?
General
