How to troubleshoot Black & Decker Remote Starter that fails to jump-start?
If your Black & Decker Remote Starter unit fails to jump-start, first ensure that the power switch is in the ON position and that the Jump-Starter has a full charge. If not, recharge the unit. Also, verify that a proper polarity cable connection has been established. For optimal performance, leave the charger plugged in and keep the unit on charge for 24-48 hours.
What to do if Black & Decker 500AMPJUMP-STARTER WITHINFLATOR portable inflator will not inflate?
If the portable inflator on your Black & Decker Remote Starter will not inflate, make sure the inflator power switch is in the ON position and that the jump-starter has a full charge. Recharge the unit if necessary. Also, ensure the connector is pushed to the valve stem and the thumb latch is closed when inflating tires, or that the nozzle (adapter) is securely inserted into the connector (chuck) on all other inflatables.
Why Black & Decker 500AMPJUMP-STARTER WITHINFLATOR USB power port will not power appliance?
If the USB power port on your Black & Decker Remote Starter will not power the appliance, first ensure that the USB charging port ON/OFF pushbutton is in the ON position. Also, check that the jump-starter has a full charge; recharge it if needed.
What to do if Black & Decker Remote Starter LED area light does not come on?
If the LED area light on your Black & Decker Remote Starter does not come on, verify that the LED area light ON/OFF button is in the ON position and that the jump-starter has a full charge. Recharge the unit if necessary.
Explains safety symbols, general precautions, and instructions for all appliances.
Covers electrical safety, extension cord usage, and recommendations for safe operation.
Details personal safety, including safety equipment and protective gear recommendations.
Highlights important warnings for burst hazards, shock hazards, explosive gases, and injury risks.
Guidelines for operating in a safe, dry, well-ventilated area, and avoiding flammable liquids.
Step-by-step instructions for connecting jumper cables to the battery and vehicle chassis.
Procedure for safely disconnecting jumper cables after jump-starting a vehicle.
Information regarding FCC rules and measures to correct radio or television interference.
Instructions for charging the unit using the 120 Volt AC Charger and extension cord.
Detailed steps for jump-starting vehicles with negative or positive ground systems.
How to use the USB power port for charging external devices and its limitations.
Instructions for using the built-in inflator for tires and other inflatables.
Guidance on connecting the inflator hose to valve stems and using adapters.
Solutions for issues like the unit failing to jump-start or the inflator not working.
General| Peak Amps | 500 |
|---|---|
| Inflator | Yes |
| USB Port | Yes |
| LED Light | Yes |
| Battery Voltage | 12V |
| Power Source | Battery |
| Battery Type | Lead Acid |
| Inflator Pressure Range | Up to 120 PSI |
| Clamp Cable Length | 24 in |
| Dimensions | 11.5 x 9.5 x 5.5 in |
To Next Page