To Next PageTo Next PageWhat to do if Black & Decker BC12 shows reverse polarity?
If you encounter reverse polarity with your Black & Decker Automobile Battery Charger, it means the battery clamps are incorrectly connected. Disconnect the clamps and ensure you connect them properly.
Why is my Black & Decker Automobile Battery Charger overheating?
If the temperature of your Black & Decker Automobile Battery Charger is too high, this may be due to high ambient temperature. Ensure adequate ventilation around the charger. It will resume charging after cooling down.
What to do if Black & Decker BC12 battery voltage is low after charging?
If the battery voltage is less than 10V after 10 minutes of charging with your Black & Decker Automobile Battery Charger: * There may be a short circuit in the battery, you should go to a professional Lab to test the battery. * A load may be connected to the battery, so disconnect the load and try charging again. * If the battery voltage is still less than 13V after multiple reconditioning attempts, replace the battery.
Why is the charge current too high on my Black & Decker BC12 Automobile Battery Charger?
If the charge current is too high on your Black & Decker Automobile Battery Charger, a load may be connected to the battery. Disconnect the load and try charging again.
Why Black & Decker Automobile Battery Charger switches to Floating charging Mode?
If your Black & Decker Automobile Battery Charger changes from maintenance mode to floating charging mode: * The charge current might be too low to fully charge the battery, so select a higher charge rate. * There may be a short circuit in the battery, so go to the specialist to check the battery. * The battery may be used during charging, so disconnect the load. * The self-discharging current may be larger than the floating current, so select a charger with a higher charging rate.
Why is the charge voltage too high on my Black & Decker Automobile Battery Charger?
If the charge voltage is too high with your Black & Decker Automobile Battery Charger, the battery may be a 24V battery instead of a 12V battery. Confirm that the battery is 12V.
Critical warning to read the instruction manual before using the product.
Safety measures for electrical connections, cords, and outlets.
Warnings covering burst, shock, and explosive hazards related to batteries.
Safety precautions unique to using the jump starter feature.
Guidelines for safe battery handling, charging, and avoiding damage.
Warnings regarding water, fire, smoke, and proper charger usage.
List of fault codes, their conditions, possible causes, and recommended solutions.
General| Input Voltage | 120V AC |
|---|---|
| Output Voltage | 12V DC |
| Output Current | 12A |
| Battery Type | Lead Acid |
| Dimensions | 10.6 x 5.3 x 9.3 inches |
| Features | Reverse polarity protection |
| Charging Amperage | 12A |
| Charging Time | Varies by battery |
| Weight | 4.4 lbs |
| Cable Length | 36 inches |
| Warranty | 2 year limited |
