4
• ANSIZ87.1eyeprotection(CAN/CPA
Z94.3),
• ANSIS12.6(S3.19)hearing
protection,
• NOSH/OSHArespiratoryprotection.
WARNING: Use of this tool can
generate and/or disperse dust, which
may cause serious and permanent
respiratory or other injury. Always use
NIOSH/OSHA approved respiratory
protection appropriate for the dust
and body.
CAUTION: Wear appropriate hear-
ing protection during use. Under some
conditions and duration of use, noise from
this product may contribute to hearing loss.
SAVE THESE
INSTRUCTIONS
SYMBOLS
The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ...... alternating current
or DC ...direct current
n
o ................no load speed
................Class I Construction
(grounded)
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
reciprocation per minute
................Read instruction manual before use
.................Use proper eye protection
................Use proper hearing protection
................Use proper respiratory protection
SFPM ......... surface feet per minute
SPM ............ Strokes per minute
•
to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. The table shows the correct
size to use depending on cord length and
nameplate ampere rating. If in doubt, use
gauge number, the heavier the cord.
FUNCTIONAL DESCRIPTION
1. Variable speed switch
4. Shoe
6. “CurveControl
TM
” dial
CurveControl™
ASSEMBLY
WARNING: Laceration Hazard. Before
attempting any of the following operations,
unplugged and that the saw blade has
stopped. Used saw blades can be hot.
FITTING THE SAW BLADE (FIGURE A)
teeth facing forward.
shoe (4).
blade holder (8) as far as it will go.
2
3
4
6
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
AmpereRating
More Not more American Wire Gage
Than Than
1
5
A
8
3
7
To Next Page
Loading...
Need help?
General
