POWERBOOST FEATURE
The POWERBOOST feature is located on the powerhead. It allows you to optimize the tool’s performance and boost
the power as needed.
Switch the blower ON.
To activate the “Boost” mode, slide the POWERBOOST button 3 towards the auxillary handle.
To deactivate the “Boost” mode, slide the POWERBOOST button 3 away from the auxillary handle.
NOTE: Operate in Normal mode for most blowing needs. Activate Boost mode as needed to clear or vacuum heavy
debris.
Cord Retainer
A cord retainer is incorporated into the rear of the power head. It can be used in two different ways:
To use the cord retainer as shown in Fig. M, hook the extension cord under the retainer. Then plug the cord
from the power head into the extension cord.
To use the cord retainer as shown in Fig. M, loop the extension cord over the power head cord and plug the two
ends into each other. Then hook the extension cord under the retainer.
To Next Page
Loading...
Need help?
General
