equipment must be used with a suitable polarized 2 wire or 3 wire extension cord. Polarized connections will fit
together only one way. Make sure that the receptacle end of the extension cord has large and small blade slot widths.
If the plug does not fit fully into the extension cord, reverse the plug. If it still does not fit, obtain a suitable extension
cord. If the extension cord does not fit fully into the outlet, contact a qualified electrician to install the proper outlet. Do
not change the tool plug or extension cord in any way.
The label on your tool may include the following symbols.
The symbols and their definitions are as follows:
SAVE THESE INSTRUCTIONS FOR FUTURE USE
COMPONENTS
Refer to Figure A at the beginning of this manual for a complete list of components.
INTENDED USE
This appliance is designed for household outdoor blower applications.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
To Next Page
Loading...
