To Next Page
K
kennedybarbaraAug 8, 2025
What to do if my Black & Decker CS1004-BR will not start?
- JJohn FieldsAug 8, 2025
If your Black & Decker Saw doesn't start, here are a few things to check: * Ensure the cord is properly plugged into a working outlet. If it isn't, plug it in. * Check the circuit fuse. If it's blown, replace it. If the fuse repeatedly blows, stop using the saw and have it serviced by a BLACK+DECKER service center or authorized servicer. * Examine the circuit breaker. If it's tripped, reset it. If the breaker repeatedly trips, discontinue use and have the saw serviced by a BLACK+DECKER service center or authorized servicer. * Inspect the cord and switch for damage. If either is damaged, have them replaced at a BLACK+DECKER Service Center or Authorized Servicer.
General
