To Next PageTo Next Page
Need help?Do you have a question about the Black & Decker FIRESTORM FS210LS and is the answer not in the manual?
General| Type | Circular Saw |
|---|---|
| Power Source | Corded Electric |
| Voltage | 120V |
| No Load Speed | 5300 rpm |
| Blade Diameter | 7-1/4 inches |
| Depth of Cut at 45 degrees | 1-3/4 in |
Defines safety alert symbols used in the manual for hazard communication.
Provides essential advice for safe operation and injury prevention.
Lists crucial safety rules to follow for preventing serious injury during operation.
Specific safety precautions and guidelines for operating table saws.
Details the electrical requirements and motor specifications for the table saw.
Explains the critical importance of proper grounding to prevent electric shock.
Provides a chart for selecting the correct gauge extension cord based on length and amperage.
Introduces the table saw model and its key features.
Lists the necessary tools for assembling the table saw.
Identifies the major components of the table saw.
Lists components for the rip fence assembly.
Lists components for the blade raising and lowering mechanism.
Lists components for the miter gage holder assembly.
Lists components for the splitter bracket assembly.
Lists components for the fence rail assembly.
Lists components for the outfeed support assembly.
Identifies the components of the saw stand.
Provides step-by-step instructions for assembling the miter gage holder.
Instructions for attaching the dust bag to the stand.
Details the process of mounting the saw onto the assembled stand.
Step-by-step guide for assembling the blade height adjustment handwheel.
Instructions for assembling the blade guard and splitter for kickback prevention.
Details the critical alignment process for the splitter and guard assembly.
Instructions for attaching the left and right extension wings to the table.
Steps for attaching the guide rails to the saw table and extension wings.
Explains how to move and lock the rip fence for ripping operations.
Describes how to insert and use the miter gage in the table slots.
Instructions for assembling and installing the outfeed support.
How to turn the saw on and off using the main switch.
Procedure for securing the switch in the off position to prevent unauthorized use.
How to operate the handwheel to adjust the blade's cutting depth.
Explains how to tilt the blade and secure it using the lock handle.
Procedure for setting accurate 90 and 45-degree blade tilt positions.
How to align the rip fence parallel to the miter gage slot for accurate cuts.
How to use the miter gage, adjust index stops, and set angles.
Steps to ensure the blade is perfectly parallel to the miter gage slots.
Detailed instructions on how to safely remove and install a saw blade.
Explains the technique and safety for cross-cutting using the miter gage.
Guide to performing rip cuts safely using the rip fence and guard.
How and why to add wood facings to the rip fence for specific operations.
Instructions for installing and using the dado cutterhead accessory.
Safety notes and procedures for performing dado cuts.
Dimensions and instructions for building a featherboard for workpiece control.
A guide to diagnosing and resolving common problems encountered with the saw.
Instructions and dimensions for making a push stick for safe feeding of narrow workpieces.
Information on available accessories and where to get them.
Guidelines for tool maintenance and details on service centers.
Details the two-year home use warranty and contractor limitations.
