13
Note: The blade attachments are very sharp. Use caution when handling and
storing.
4. Place food in workbowl.
5. Place lid on workbowl and lock into place by rotating lid
counterclockwise.
6. Make sure food pushers are securely in place in feed chute. Never use
your fingers to direct food through chute.
7. Press speed button to process.
8. To add food or liquid while processor is running, remove food pusher
and insert through the feed chute. Replace food pusher in chute.
9. When finished, press the PULSE|OFF button and allow blades to stop revolving
before removing lid. Twist lid clockwise to remove from the workbowl.
Important: Be sure S blade has completely stopped spinning and unplug
appliance before removing lid from processor.
10. To unlock workbowl, turn it clockwise and lift off base.
11. Carefully remove S blade by pulling shaft straight
up and empty workbowl.
Note: To remove S Blade from blade shaft, turn
counterclockwise and pull blade shaft out
from bottom. (P)
12. Unplug appliance when not in use.
USING THE MINI S BLADE IN
THE SMALL WORKBOWL
1. Lock large workbowl into position on food
processor base.
2. Place small workbowl in large workbowl, fitting
the tabs on the outside of the small bowl into the
notches on the large workbowl. This will hold the
small bowl firmly in place. (Q)
3. Carefully place the mini S blade on blade shaft in bottom of workbowl.
4. Place lid on workbowl and lock into place by rotating lid
counterclockwise.
5. Follow remaining steps as outlined in USING THE S BLADE IN THE
LARGE WORKBOWL.
Important: Disks and blades must be removed before removing small
workbowl.
6. To remove small workbowl from large workbowl, use the two finger
grips to lift up.
To Next Page
Loading...
Need help?
General
