Black & Decker FP2500MC

Questions and Answers

L
Luke HorneAug 10, 2025
Why is food unevenly chopped in my Black & Decker FP2500MC?
- D
  Doris PachecoAug 10, 2025
  If your Black & Decker Food Processor is chopping food unevenly, it could be due to a few reasons. The workbowl might be overfilled, or you may be running the bowl continuously instead of using the PULSE (P) setting, or the food may be cut in random sizes. To fix this, process smaller amounts for more even results. Use the PULSE (P) button in short, 5-second increments or less, allowing the blades to stop completely before pulsing again. Also, ensure that you cut the food into uniformly sized pieces before placing them in the processor.
V
Valerie YoungAug 15, 2025
What to do if liquid leaks from the bottom of my Black & Decker FP2500MC Food Processor?
- M
  Mason SotoAug 15, 2025
  If liquid is leaking from the bottom of the workbowl of your Black & Decker Food Processor, it's likely due to having too much liquid in the bowl. To prevent this, process smaller amounts at a time. When processing liquids, do not exceed 3 cups in the workbowl. Also, make sure not to remove the blade before removing the workbowl from the processor when working with liquids.
M
Maria GallowayAug 20, 2025
How to fix uneven and slanted slices in Black & Decker Food Processor?
- B
  biancameyerAug 21, 2025
  Uneven and slanted slices from your Black & Decker Food Processor can occur if the feed chute isn't well-packed or if uneven pressure is applied to the food pusher during processing. Ensure that the pieces you're slicing are of even lengths, slightly shorter than the feed chute. Pack the chute carefully and maintain consistent pressure on the food pusher as the food is processed.
D
Deanna GreenAug 25, 2025
Why does soft cheese collect on the disc of my Black & Decker Food Processor?
- J
  Joseph MarquezAug 26, 2025
  If soft cheese collects on top of the slice/shred disc in your Black & Decker Food Processor, it's probably because the cheese wasn't cold enough, or too much pressure was exerted on the pusher. Ensure soft cheeses are well-chilled, or place them in the freezer until a knife inserted into the cheese penetrates about ½-inch. Remember to use the food pusher as a guide and avoid applying hard pressure.
T
Tyler WaltersAug 30, 2025
What to do if foods fill up on one side of the bowl in Black & Decker FP2500MC Food Processor?
- R
  Rhonda MccallAug 30, 2025
  It's normal for foods being sliced or shredded to fill up on one side of the bowl in your Black & Decker Food Processor. To manage this, occasionally stop processing and either even out the food in the workbowl or move it to another bowl. When food accumulates close to the disc, empty the workbowl before continuing.
R
Richard ButlerSep 4, 2025
Why do pieces of food remain on top of the disc in my Black & Decker FP2500MC?
- S
  Scott SmithSep 4, 2025
  It is normal to have some pieces of food remain on top of the slicing/shredding disc of your Black & Decker Food Processor. You can slice or shred those pieces by hand or save them for another use, like soups that will be pureed.