To Next PageTo Next Page
Need help?Do you have a question about the Black & Decker GC1800 and is the answer not in the manual?
General| Type | Cordless Drill |
|---|---|
| Voltage | 18V |
| No Load Speed | 0-750 RPM |
| Power Source | Battery |
| Chuck Size | 3/8 inch |
| Speed | 2-speed |
Keep work area clean, avoid explosive atmospheres, and keep bystanders away.
Use proper plugs, avoid grounded surfaces, protect from rain/wet, don't abuse cords, use outdoor/GFCI cords.
Stay alert, use PPE, prevent unintentional starting, remove adjusting keys, maintain balance.
Explanation of symbols found on the tool label, including V, Hz, min, DC, Class I, Class II, A, W, AC, no, earthing terminal, safety alert symbol, rpm.
Read instructions, avoid shock hazard, prevent burn hazard, keep foreign materials away, unplug when not in use.
Use appropriate AWG size for extension cords to prevent fire, shock, or electrocution.
Ensure ventilation, place on stable surface, disconnect damaged cords, do not disassemble.
Do not incinerate, avoid explosive atmospheres, handle skin/eye contact with liquid, ensure ventilation.
Charge only with designated chargers, do not splash liquid, avoid high temperatures.
Do not open cracked packs, protect terminals from contact, store in cool, dry place.
Identifies key parts of the drill: switch, button, collar, chuck, battery, release, holder, charger.
Steps for charging using a jack plug charger, including initial charge time.
Steps for charging using a cup charger, including initial charge time.
Optimal charging temperatures and conditions for battery life.
Hold firmly with two hands, hand-tighten chuck securely.
Use trigger for speed control, forward/reverse button for direction and lock-off.
Adjust collar for torque setting for screws; use drilling position for drilling.
How to install/remove drill bits by hand-tightening the chuck.
Use sharp bits, secure work, use safety equipment, apply steady pressure, hold firmly.
Use twist or spade bits, keep sharp, clear chips frequently.
Use cutting lubricant for most metals; drill cast iron/brass dry.
Use carbide tipped bits, apply even force, monitor dust for rate.
Clean with mild soap/damp cloth, avoid liquids. Repairs by authorized centers only.
Check battery installation, charge, or ensure it's properly inserted.
Ensure charger is plugged in, battery is inserted, and temperature is suitable.
Use recommended accessories, specifies bit sizes for metal, masonry, and wood drilling.
Information on recycling rechargeable batteries through the RBRC program.
Contact BLACK+DECKER service centers for advice, repair, or parts.
Covers defects for 2 years, excludes abuse, accidental damage, unauthorized repairs.
Product replacement or repair at retailer or authorized service center.
