Black & Decker KA210 - Reversing the Pointed Base; Fitting the Sandpaper (Pointed Base); Tip Components (Pointed Base); Fitting the Profile Base

8
washer in position on the base and fit the screw using
the allen key provided. Press the base on firmly when
tightening the screw.
REVERSING THE POINTED BASE
(KA210/KA210E/KA220/KA220E/KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
Turn the screw
anticlockwise using the
allen key provided in
the handle. Remove the
screw and the washer
from the spindle. Hold
the base in position
with the point facing
rearwards. Fit the washer and the screw. Tighten the
screw using the allen key provided. Press the base on
firmly when tightening the screw.
FITTING THE SANDPAPER (POINTED BASE)
Proceed as follows:
Disconnect the plug from the electricity supply.
Detach the two
diamond-shaped tips
from the main sheet.
Place the sandpaper
on the pointed base,
making sure the holes
of the paper and the
base are aligned.
Never use your multi
sander without sandpaper and always use a full sheet
of sandpaper.
TIP COMPONENTS (POINTED BASE)
(KA210/KA210E/KA220 /KA220E/KA230E)
Each sheet of
sandpaper has a
removable tip, with two
spare tips attached. To
obtain maximum use
from each sheet, detach
and turn the tip when the
front part is worn.
When the whole tip is worn, replace it with one of the
spare tips provided. The tip of the backing pad is
removable. When the front part is worn, turn the tip.
When the tip is completely worn, replace the tip. Spare
tips are available as accessories. When the tip of the
hard plastic tip holder is worn, remove the screw and
turn the holder. Spare holders are available as
accessories.
FITTING THE PROFILE BASE (KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
Position the profile
base on the spindle,
with the long section
pointing towards the
front of your sander.
Make sure the legs fit
into their housings.
Place the washer in
position on the base
and fit the screw using
the allen key provided.
Press the base on firmly when tightening the screw.
FITTING THE SANDING PROFILE (KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
There are six sanding
profiles supplied, each
being different in size
and shape. Select the
sanding profile most
suitable for the task
and push into the slot in
the front of the base.
To do this, first locate
one end of the sanding
profile into the recess
at the back of the
profile base slot, then
push the other end so
that it locates in the
recess in the front of the profile base. The sanding
profile will now be positively located. The sanding
profile can be removed by depressing the small black
square section which is visible at the front of the
profile base, whilst pulling the profile away from its
locating slot.
FITTING THE SANDING PAPER (PROFILE BASE)
(KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
With the profile fitted in the base, fit the paper by
applying light pressure making sure that the paper
ENGLISH