11
DRILLING IN METAL
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which
should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.
DRILLING IN MASONRY
Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the drill but
not so much that you crack the brittle material. A smooth, even flow of dust indicates the
proper drilling rate.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
TROUBLESHOOTING
Problem PossibleCause PossibleSolution
•Unit will not start. •Batterypack notinstalled •Checkbattery pack
properly. installation.
•Battery pack notcharged. •Checkbattery pack charging
requirements.
•Battery pack willnot •Battery pack notinserted into •Insert battery pack into
charge. charger. charger untilgreenLEDappears.
•Charger notplugged in. •Plugcharger into a working
outlet. Refer to“ImportantCharging
Notes” for more details.
•Surroundingairtemperature •Move charger and battery
toohotortoocold. pack toa surrounding air temperature of
above 40degrees F (4.5°C) or below
105degrees F (+40.5°C).
•Unitshuts off abruptly. •Battery pack hasreached its •Allow battery packto cool
maximum thermal limit. down.
•Outof charge. ( To •Placeoncharger and
maximizethelifeofthe allowtocharge.
batterypackitisdesigned
toshutoff abruptly when
thecharge is depleted.)
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be
hazardous.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Black & Decker. In some areas, it is illegal to place spent lithium-ion batteries
in the trash or municipal solid waste stream and the RBRC program provides an
environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent lithium-ion
batteries. Help protect our environment and conserve natural resources by returning the
tool to an authorized Black & Decker service center for recycling. You may also contact
your local recycling center for information on where to drop off the spent battery, or cal
1-800-8-BATTERY.
To Next Page
Loading...
