2. Fill the Water Tank to the water
full mark (approximately 4 oz.).
(See “Filling With Water,” below )
3. Plug the iron into a standard
(polarized) electrical outlet.
4. Set the Temperature Selector/
Heat Fabric Guide to the Cotton
setting and preheat for about 30
seconds. (See “Starting The Iron,”
page 6)
5. While ironing on an old cotton
terry cloth towel for about two
minutes, try using each of the
iron’s features:
Spray: Pump the SPRAY Button a
few times to see the amount of
water that is released.
Steam Settings: Turn the
Adjustable Steam/Dry Dial to the
Indicator Mark for (light),
(medium), and (heavy) set-
tings to become familiar with the
different amounts of steam at
each setting.
FILLING WITH WATER
NOTE: When filling, be sure the
iron is unplugged, the Temperature
Selector Dial is in the O/FILL posi-
tion, and the Adjustable Steam/Dry
Dial is in the Dry position.
5
To Next Page
Loading...
