Black & Decker PROFESSIONAL WorkMate 2000 - Standard Equipment; Assembly Instructions

ASSEMBLY INSTRUCTIONS
With the legs in the
vertical position lock 5 ? = J
the metal struts as shown >- V,
Fig. 2
Remove the WM2000 from packaging
ensuring that the centreboard is clamped
securely between the vice jaws.
Place the WM2000 on floor as shown in
fig. 2 and release the two retaining
catches and open the first pair of legs,
with the legs in vertical position lock the
metal struts as shown.
Release the remaining set of legs and
follow above procedure.
Note: Before placing the WM2000 in the
upright position ensuring all four metal
struts are locked securely.
STANDARD EQUIPMENT
Each WM2000 is supplied with:
(A) Four vice pegs - ideal for clamping
irregular shaped work pieces safely fig. 3.
(B) Two jaw protectors - ideal for
gripping pipes etc, securely either
vertically or horizontally.
(C) Two metal drawing board brackets
as shown in fig. 9.
Vice jaw protectors