Black & Decker STC1820EPCB

Questions and Answers

T
thomashodgeAug 11, 2025
What to do if the automatic line feed doesn't work on my Black & Decker STC1820EPCB?
- M
  Megan RiveraAug 11, 2025
  If the automatic line feed on your Black & Decker Trimmer isn't working, try these steps: Let the line wear down to approximately 76 mm to see if it feeds then. Remove the spool cap and spool, ensuring the line isn't crisscrossed. If it is, rewind it neatly. Inspect the spool for damage and replace if needed. Pull the cutting line until it extends about 122 mm from the spool. If these steps don't work, clean the spool and housing, ensure you're using the correct 2.00 mm line size, check if the lever in the spool housing moves freely, and rewind the cutting line neatly before replacing the spool.
N
Nichole DunnAug 18, 2025
What to do if the line unravels when removing the cap or spool on my Black & Decker STC1820EPCB Trimmer?
- D
  Dale AcostaAug 19, 2025
  To prevent the line from unraveling when removing the cap or spool on your Black & Decker Trimmer, make sure to park the lines in the holding slots before removing them.
T
Taylor TerrellAug 26, 2025
What to do if the line unravels when I remove the cap or spool from my Black & Decker STC1820EPCB?
- D
  davistomAug 26, 2025
  To prevent the line from unraveling when removing the cap or spool from your Black & Decker Trimmer, make sure to park the lines in the holding slots before removal.
D
Dominique TranSep 2, 2025
How to fix a Black & Decker STC1820EPCB Trimmer that runs slowly?
- S
  Shawn HoweSep 2, 2025
  To fix a slow-running Black & Decker Trimmer, first remove the battery. Then, check if the spool housing can rotate freely and clean it if necessary. Also, ensure that the cutting line does not protrude more than approximately 122 mm from the spool; if it does, cut it off so that it just reaches the line trimming blade.