14
ASD-4
To install the ASD-4 with a two-line phone and (optionally) a two-line TAD on
one line of a two-line system, as shown in Figure 3-7 on the next page, follow
these steps:
NOTE
This section assumes that the ASD-4 will be installed on the secondary
line (L2). To Install the ASD-4 on the primary line, reverse “L1” and “L2”
in these directions: Where the directions specify attaching a cable to
“L1,” attach it to “L2,” and vice versa.
1. Plug one three-way adapter into the wall jack.
2. Plug the other three-way adapter into the two-line telephone. The jack on
the two-line telephone might be labeled “L1+L2.”
3. Plug one end of a phone cable into the “L1” port on one of the adapters.
Plug the other end of the cable into the “L1” port on the other adapter.
4. Plug one end of a second phone cable into the “L2” port on the
wallmounted adapter. Plug the other end of the phone cable into the
LINE-IN port on the rear panel of the ASD-4.
5. Plug one end of a third phone cable into the PHONE port on the rear
panel of the ASD-4. Plug the other end of the phone cable into the “L2”
port on the adapter connected to the telephone.
6. If you’re using a two-line TAD: Run the phone cable supplied with your
TAD from the TAD’s “L1+L2” port to the “L1+L2” port of the three-way
adapter connected to the telephone.
7. Connect other telephone equipment to the ASD-4 as described in Section
3.3.
Figure 3-6. A three-way phone adapter.
To Next Page