Black Box ASD-4 - Function [8]: RMN Conditions; Function [9][9][9]: Reset to Factory Settings

60
ASD-4
5.4.14 F UNCTION [8]: RMN C ONDITIONS
The RMN Conditions function allows you to define which port’s or ports’
being accessed will trigger RMN (see Section 4.4): Condition [1] = TAD
access, [2] = FAX access, and [3] = MODEM access. The function is factory-
preset to trigger RMN only when a TAD message is received, [8] [1] [*].
Example: To change the RMN Conditions to trigger RMN under all
conditions (when a TAD or FAX message is received or MODEM access
occurs), enter the programming mode and press the following on your tone
phone:
[8] Change RMN Conditions to
[1] [2] [3] Trigger RMN when any of the three ports is accessed
[*] End programming sequence (3 beeps indicate correct entry)
.
. (Optional entries for additional changes)
.
[*] Save changes and exit programming
NOTE
Press the keys for your desired RMN Conditions in numerical order (that
is, [1] first, then [2], then [3]).
5.4.15 F UNCTION [9][9][9]: R ESET TO F ACTORY S ETTINGS
To reset all features and functions to their original factory settings, enter the
programming mode and press the following on your tone phone:
[9][9][9] Reset to Factory Settings
[*] End programming sequence (3 beeps indicate correct entry)
.
. (Optional entries for additional changes)
.
[*] Save changes and exit programming