Black Box ASD-4 - Feature [7]: Reverse Modem Detection; Feature [8]: Remote Message Notification (RMN)

47
CHAPTER 5: Programming the ASD-4
5.3.8 F EATURE [7]: R EVERSE M ODEM D ETECTION
This feature determines whether or not the ASD-4 automatically routes a call
to either the MODEM or FAX port (depending on the setting of feature
[1][1], Reverse Modem Port Selection) when it detects the reverse modem
signal. For more details about reverse modem signals, see Section 4.2.7.C.
The Reverse Modem Detection feature is factory-preset ON, [1] [7] [*].
Example: To turn Reverse Modem Detection OFF, enter the programming
mode and press the following on your tone phone:
[0] Turn OFF
[7] Reverse Modem Detection
[*] End programming sequence (3 beeps indicate correct entry)
.
. (Optional entries for additional changes)
.
[*] Save changes and exit programming
5.3.9 F EATURE [8]: R EMOTE M ESSAGE N OTIFICATION (RMN)
This feature determines whether or not the ASD-4 dials a pre-programmed
telephone number (programmed with function number [7], RMN Phone
Number) after any port or combination of ports have received a call. The
ASD-4 must be pre-programmed with the RMN Phone Number and the type
of conditions that trigger RMN (see Sections 4.4 and 5.4.14). The RMN
feature is factory-preset OFF, [0] [8] [*].
Example: To turn the RMN feature ON, enter the programming mode and
press the following on your tone phone:
[1] Turn ON
[8] Remote Message Notification
[*] End programming sequence (3 beeps indicate correct entry)
.
. (Optional entries for additional changes)
.
[*] Save changes and exit programming