Max Express Ethernet Switch LB9217A-R2 & Applicable Modules
10
Module Installation
There are two sets of different modules available for LB9217A-R2, the base unit
for Max Express Ethernet Switch. Modules LB9213A~LB9219A are equipped
with 8 ports TX/FX while LB9220C-ST & LB9220C-SC are designed with one
fiber port to meet different needs in your network environment. Please see page
9
for detailed information.
A B C
Figure 2: Position A & B are designed for 8-port module, position C is for
single port module only
Step by Step Installation for 8-port Module:
LB9213A, LB9214A, LB9215A, LB9216A, LB9218A, LB9219A
1. Remove the module from the static-free container.
2. Unscrew the cover plate(s) from base unit on position A and or B.
3. Remove the plate and keep it for future use if modules need to be removed
later on.
4. With the power off, slide the module(s) into the desired slot, following the
internal plastic guide rails.
5. Once it is slid in fully, snap in the module to make a proper connection
and fasten the screws.
<NOTE> Before you start with any installation, ensure that the power is off.
The module is not hot swappable.
To Next Page
Loading...
