Black Box LPB2910A - Page 355

Page 343
Figure 9-1. Switch’s serial number in the GUI.
2. In the CLI, use the command “Show System” to display the switch’s security code (serial number).
Figure 9-2. Switch’s serial number in the CLI.
3. E-mail the security code (serial number) to your Black Box contact so an authencaon code can be created.
4. Black Box will send you an email cercate with the Authencaon Code.
5. Log into the CLI. Then run the command: “media controller (Authencaon Code) enable/disable.” Paste the Authencaon Code
you received into the command where you see the (Authencaon Code). The image on the next page shows how the command
will look.