Black Max BM907500BT User Manual (English)

Other manuals for Black Max BM907500BT

Questions and Answers:

E
Erica VargasAug 1, 2025
What to do if my Black Max Inverter engine will not start?
- E
  Eric RodgersAug 1, 2025
  If your Black Max Inverter engine won't start, there are several potential causes: * The on/off switch may be OFF. Turn it ON. * The fuel tank may be empty. Fill it with fuel. * The gasoline may be stale or contain water. Drain the system and refill with fresh fuel. * The lubricant level may be low. Check and fill if necessary. * The fuel valve may be OFF. Turn it ON. * The spark plug may be faulty. Replace it. * The choke may be in the RUN position. Pull the choke lever to the START position. * The engine may have been stored improperly. Drain the fuel and carburetor, then refuel with fresh gasoline. * The fuel filter may be dirty. Replace it.
E
ecaseyAug 5, 2025
Why is my Black Max Inverter AC receptacle not working?
- P
  pwebbAug 5, 2025
  If the AC receptacle on your Black Max Inverter isn't working, it could be due to a tripped circuit breaker. Try resetting the AC circuit breaker. Alternatively, the GFCI might be tripped, so try resetting the GFCI. Finally, the item you've plugged in might be defective; try a different item to check.
L
loriholmesAug 10, 2025
What to do if electric start feature is not working on Black Max BM907500BT Inverter?
- B
  byrdbrittneyAug 10, 2025
  If the electric start on your Black Max Inverter isn't working, check the following: 1. Ensure the on/off switch is in the ON position. 2. If the MAXCONTROL LCD display is in sleep mode, press the pairing button or toggle the on/off switch to wake it. 3. Make sure the battery wires are connected. 4. Check if the battery is charged and charge it if necessary. 5. Inspect the engine battery charge circuit fuse and replace it if blown.
D
dbrownAug 13, 2025
Why Black Max BM907500BT engine lacks power?
- P
  philipjonesAug 14, 2025
  Your Black Max Inverter engine may lack power due to a dirty air filter. Check the air filter and clean or replace it as needed. Another cause could be that the engine was stored without treating or draining gasoline, or it was refueled with bad gasoline. In this case, drain the fuel and carburetor and refuel with fresh gasoline.
C
Caroline MillerAug 18, 2025
How to fix a Black Max BM907500BT that is hard to start?
- G
  gchenAug 18, 2025
  If your Black Max Inverter is hard to start, it might be due to water in the gasoline. Drain the entire system and refill with fresh fuel. Another possible cause is a weak spark at the spark plug.
J
Jenna DukeAug 22, 2025
Why does my Black Max BM907500BT Inverter generator make a 'spark knock' or 'pinging' noise?
- L
  Lisa OlsonAug 23, 2025
  An occasional light knocking or pinging under a heavy load is usually not a concern. However, if the knocking or pinging occurs under normal load at a steady engine speed, switch to a different brand of gasoline, ensuring the octane rating is 86 or higher. The problem may be with the brand of gasoline being used.
R
Robin WilliamsAug 27, 2025
What to do if MAXCONTROL LCD display ™ is not working on Black Max BM907500BT?
- A
  Ann CoxAug 27, 2025
  If the MAXCONTROL LCD display is not working on your Black Max Inverter, first, ensure the battery cables are connected. If they are, the display might be in sleep mode. Press and release the pairing button or toggle the on/off switch off and on to wake the display. Lastly, the battery charge may be very low, so recharge the battery.