STEP
Make sure LP tank is
properly connected to unit. Turn
gas ON at LP cylinder by taking 20
seconds to turn knob halfway.
! WARNING
Do not lean over griddle
while lighting.
! WARNING
If ignition does NOT
occur in 5 seconds, turn
burner controls OFF, wait
5 minutes and repeat
lighting procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner
and could accidentally/
inadvertently ignite with
risk of injury.
IGNITION |
PIEZOELECTRIC
If ignition does NOT occur in 5 seconds, turn burner control OFF, wait 5
minutes and repeat lighting procedure.
For additional support, see youtube.com/blackstonegriddles
GRIDDLE OPERATING INSTRUCTIONS
For proper ignition and operation of the griddle follow the steps below.
STEP
Adjust temperature to
desired level.
STEP
Push in control knob to
start gas owing, then turn control
knob counter-clockwise to acti-
vate starter.
Ignition | Piezo-Electric
TROUBLESHOOTING
SYMPTOMS
01. Burner will not ignite with piezo ignition system
If ignition does not occur in 5 seconds, turn the burner controls o, wait 5
minutes and repeat the lighting procedure. If this does not work, to deter-
mine the cause, please try to ignite your griddle with a match. (Please
reference the Match Lighting Instructions in the Cleaning the Burner
Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
01. Igniter wire misaligned. Ensure that the igniter wire is positioned
1/8” to 1/4” away from the burner tube,
positioned above a burner hole.
02. Damage to the ignition system. Contact customer service for replace-
ment parts.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
03. Burner tubes are not
receiving propane.
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Section 01
PIEZOELECTRIC IGNITION
TROUBLESHOOTING
TroubleshootingModel 1940 | Owner’s Manual | | Owner’s Manual | Model 1940
30 31
To Next Page