ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
| OWNER’S MANUALUSING YOUR BLACKSTONE
FIRST TIME CLEANING
CLEANING YOUR GRIDDLE TOP
NOTICE
Soap will ruin a seasoned griddle. This is the only time you
should use soap on the griddle cooking surface.
STEP 01
Wash the griddle cooking surface with hot, soapy water.
STEP 02
Rinse and dry completely.
CLEANING YOUR GRIDDLE TOP
Clean griddle top after each use, while still warm.
• DO NOT use soap on the griddle top. This will destroy the griddle’s
seasoning.
• The grease cup must be removed and emptied after each use.
CAUTION
Grease cup will be hot during and after use. DO NOT remove
the grease cup until the griddle has completely cooled.
STEP 01
Push loose food debris
into the grease cup with spatula
or straight metal scraper.
STEP 02
Wipe down griddle top
with paper towel.
STEP 03
Apply a few tablespoons
of water to the griddle surface,
then scrape the water and debris
into the grease cup.
(For stuck-on food residue, use a
bit of coarse salt.)
STEP 04
Wipe again with a paper
towel and dry completely.
STEP 05
Apply thin coat
of cooking oil to maintain
seasoning and protect the
griddle top.
VIDEO TUTORIAL
How to Clean your Blackstone Griddle
youtube.com/watch?v=-Iedu9z6NPY
LEAK TEST INSTRUCTIONS
NOTICE
DO NOT use household cleaning agents. Damage to gas valve,
hose, and regulator components may result.
Use a clean paintbrush and a 10/90 mild soap and water
solution to perform the leak test.
LEAK TEST: LPG CYLINDER
• Leak test new and exchanged LPG cylinders BEFORE connecting
to griddle.
• DO NOT smoke during leak test.
• DO NOT use an open flame to check for gas leaks.
• Appliance must be leak tested outdoors in a well-ventilated
area, away from ignition sources such as gas fired or electrical
appliances.
• During leak test, keep appliance away from open flames or sparks.
LEAK TEST: VALVES, HOSE & REGULATOR
STEP 01
Turn the control knobs to OFF.
STEP 02
Connect the regulator to the LPG cylinder.
STEP 03
Completely open the LPG tank by turning the OPD hand
wheel counterclockwise.
• If you hear a rushing sound, turn gas o immediately. There is a
major leak at the connection.
• Immediately close the LPG cylinder by turning the OPD hand wheel
clockwise and re-tighten connections. If leaks cannot be stopped
DO NOT TRY TO REPAIR.
STEP 01
Brush soapy solution
onto joint areas of the LPG
cylinder.
(Indicated by arrows in figure 01.)
(Indicated by arrows in figure 01.)
• Leaks are indicated by
growing bubbles.
WARNING
If growing bubbles appear
during leak test, DO NOT use
or move the LPG cylinder.
Immediately contact an LPG
supplier or fire department.
STEP 04
Brush soapy solution
onto joint areas of valves and
regulator.
(Indicated by arrows in figure 02.)
(Indicated by arrows in figure 02.)
• Leaks are indicated by
growing bubbles.
• Immediately close the LPG
cylinder by turning the OPD
hand wheel clockwise and
re-tighten connections.
WARNING
If leaks cannot be stopped, DO NOT try to repair.
Regulator must be replaced with a Blackstone approved
model by a professionally licensed, authorized dealer.
figure 02
figure 01
MODEL:
To Next Page
Loading...
