Black Stone 6964 - Using Your Blackstone; Connecting the LPG Cylinder; Regulator Safety and Warnings

ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
| OWNER’S MANUALUSING YOUR BLACKSTONE
REGULATOR SAFETY
 WARNING
Cross threading can occur if you force thread a connection
at an improper angle. This will damage the threads, lead to
propane leaking, and potentially result in a build-up of fuel
that can ignite.
DO NOT cross thread the connection between your LPG
cylinder and regulator or regulator and gas rail.
 WARNING
If you can not connect the regulator, DO NOT use the
regulator.
Regulator must be replaced with a Blackstone approved
model by a professionally licensed, authorized dealer.
Use this appliance, as purchased, only with gas and regulator/valve
assembly supplied.
If regulator fails in unit, it must be replaced with a Blackstone approved model
(found on your Manufacturer label) by a professionally licensed, authorized
dealer. Failure to comply will void the warranty.
CONNECT THE LPG CYLINDER
STEP 01
Screw in the LPG cylinder into the gas regulator, turning the
cylinder clockwise.
 CAUTION
Heavy pieces. Two people should assemble this appliance.
NOTICE
Place appliance on a heat-resistant and flame-resistant
surface while in use.
NOTICE
DO NOT leave the hood closed for more than 10 minutes while
cooking.
NOTICE
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc) or rechargeable
(ni-cad, ni-mh, etc.) batteries.
MODEL: 
STEP 07
Tilt the door brake behind the gauge panel and set the oven
door assembly in place.
USING YOUR BLACKSTONE
STEP 08
Proceed to USING YOUR BLACKSTONE.
