6
ENGLISH
(Original instructions)
Emptying the dust bag
The dust bag (2) should be emptied after every ten
minutes of use.
u Pull the dust bag (2) to the rear and off the tool away from
the connection port.
u Empty into a suitable receptacle and replace on tool.
Hints for optimum use
u For user comfort, the tool can be operated with one or
two hands (g. F, G, H). Do not place your hands over the
ventilation slots.
u Do not exert too much pressure on the tool.
u Regularly check the condition of the sanding sheet.
Replace when necessary.
u Always sand with the grain of the wood.
u When sanding new layers of paint before applying
another layer, use extra ne grit.
u On very uneven surfaces, or when removing layers of
paint, start with a coarse grit. On other surfaces, start
with a medium grit. In both cases, gradually change to a
ne grit for a smooth nish.
u Consult your retailer for more information on available
accessories.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Warning! Before performing any maintenance on the tool,
remove unplug the charger before cleaning it.
u Regularly clean the ventilation slots in your tool using a
soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
u Safely dispose of the old plug.
u Connect the brown lead to the live terminal in the new
plug.
u Connect the blue lead to the neutral terminal.
Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 5 A.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
BEW220
Input voltage V
AC
230
Power input W 150
No-load speed min
-1
14000
Weight kg 1.27
Level of sound pressure according to EN 62841:
Sound pressure (L
pA
) 85 dB(A), uncertainty (K) 3 dB(A)
Sound power (L
WA
) 96 dB(A), uncertainty (K) 3 dB(A)
Vibration total values (triax vector sum) according to EN 62841:
(a
h
) 11.3 m/s
2
, uncertainty (K) 1.5 m/s
2
EC declaration of conformity
MACHINERY DIRECTIVE
%
BEW220 Sander
Black & Decker declares that these products described under
“technical data” are in compliance with:
2006/42/EC, EN62841-1:2015, EN62841-2-4:2014.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact Black &
Decker at the following address or refer to the back of the
manual.
The undersigned is responsible for compilation of the techni-
cal le and makes this declaration on behalf of
Black & Decker.
R. Laverick
Director of Engineering
Black & Decker Europe, 210 Bath Road, Slough,
Berkshire, SL1 3YD
United Kingdom
31/07/2018
To Next Page
Loading...
