Page 8 Page 9
MAINTENANCE
1. Turn power off before cleaning.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth.
You may use a mild detergent if necessary. After cleaning, dry the unit with a soft
cloth.
CAUTION: DO NOT let liquid enter the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes
to clean the heater. This may cause damage or deterioration to the surface of the
heater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.
STORAGE
Store the heater in a cool, dry location when not in use. To prevent dust and dirt
build-up, use the original packaging to repack the unit.
SET UP & USE CARE & CLEANING
OPERATING INSTRUCTIONS
Place the heater on a rm, level surface and plug the unit directly into a 120 V AC
electrical outlet.
NOTE: Only operate heater in upright position.
1. Turn the heat control knob clockwise (right) from the OFF position to the LOW or
HIGH (1500 watts) heat settings. For Fan Only operation without any heat turn to
the FAN setting.
2. To adjust the thermostat, turn the thermostat knob clockwise (right) from the
MIN position to the MAX position to increase the temperature. When the desired
temperature is reached lower the thermostat setting until the heater stops
operating by turning the thermostat knob to the MIN position.
The power indicator light turns on when either the, FAN, LOW or HIGH setting is
selected.
NOTE: Turning the THERMOSTAT control knob clockwise will increase the
temperature setting.
Turn the fan/heat control knob to “OFF” to shut off the unit.
Thermostat Fan/Heat control knob
To Next Page
Loading...
