12
ENGLISH
(Original instructions)
Guidelines for trimming (Australia & New Zealand)
u Trim hedges and shrubs with seasonal leaves (new leaves
every year) in December and March.
u Trim evergreens in September and February.
u Trim conifers and other fast growing shrubs every six
weeks from October until March.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
u Switch off and unplug the appliance/tool.
u Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
u Or run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
u Regularly open the chuck and tap it to remove any dust
from the interior (when fitted).
u After use, carefully clean the blades. After cleaning, apply
a film of light machine oil to prevent the blades from
rusting.
Storage
When the tool will not be used for several months, ideally
leave the battery connected to the charger. Otherwise proceed
as follows:
u Fully charge the battery.
u Store the tool in a secure and dry location. The storage
temperature must always remain in the range of +10 °C to
+40 °C.
u Before using the tool after prolonged storage, fully charge
the battery again.
Protecting the environment
Z
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
GSL200 (H1) GSL300 (H1)
Voltage V
DC
3.6 3.6
Blade strokes (no load) min
-1
850 850
Blade length (shear) cm 10 -
Blade gap (shear) mm 23 -
Blade length (trimmer) cm - 15
Blade gap (trimmer) mm - 8
Blade brake time s
< 1 < 1
Weight kg 0.65 0.65
GSL360 (H1) GSL700 (H1)
Voltage V
DC
3.6 7.0
Blade strokes (no load) min
-1
850 850
Blade length (shear) cm 10 10
Blade gap (shear) mm 23 23
Blade length (trimmer) cm 15 15
Blade gap (trimmer) mm 8 8
Blade brake time s
< 1 < 1
Weight kg 0.65 0.65
Charger 905450xx
905527xx
9062xxxx
Input voltage V
AC
230 230
Output voltage V
DC
9 10
Current mA 100 120
Approx. charging time h 19 14
Weight kg 0.15 0.15
Level of sound pressure according to EN 60745:
Sound pressure (L
pA
) 66 dB(A), uncertainty (K) 3 dB(A)
Sound power (L
WA
) 77 dB(A), uncertainty (K) 3 dB(A)
Vibration total values (triax vector sum) according to EN 60745:
(a
h
) 3.1 m/s
2
, uncertainty (K) 1.5 m/s
2
To Next Page
Loading...
