6
ENGLISH
(Original instructions)
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool along with the
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear safety glasses or goggles when operating
this tool.
Wear ear protection when operating this tool.
Immediately disconnect the cable from the mains
if it is damaged or cut.
Do not expose the tool to rain or high humidity.
Directive 2000/14/EC guaranteed sound power.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u When using the tool outdoors, only use extension
cables intended for outdoor use. A suitable rated
BLACK+DECKER extension cable of up to 30 m can be
used without loss of power.
u Electric safety can be further improved by using a high-
sensitivity 30 mA residual current device (RCD).
Features
This tool includes some or all of the following features.
1. Trigger switch
2. Front handle switch
3. Front handle
4. Guard
5. Blade
6. Cable restraint
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged and that the blade sheath is tted
over the blades.
Fitting the guard (g. A & B)
u Remove the two partially inserted screws from the body of
the tool.
u Locate the guard (4) into the grooves.
u Secure the guard using the two screws (7) supplied.
Warning! Never use the tool without the guard.
Connecting the tool to the mains (g. C)
Unless the tool is tted with a mains cable, you will need to
connect an extension cable to the power inlet.
u Connect the female socket of a suitable extension cable to
the power inlet of the tool.
u Loop the cable through the cable restraint (6) as shown
to prevent the extension cable from becoming detached
during use.
u Insert the mains plug into a mains outlet.
Warning! The extension cable must be suitable for outdoor
use. When using a cable reel, always unwind the cable
completely.
Use
Warning! Let the tool work at its own pace. Do not overload.
Rotating the front handle (g. D) (GT4550 Only)
For you comfort and convienience during use, the front handle
can be rotated into 5 different positions.
u Press in the front handle rotate button (8).
u Rotate the front handle (3) to the required position.
u Release the front handle rotate button (8).
Note: It is not possible to rotate the front handle of the hedge
trimmer whilst the hedge trimmer is running.
Switching on and off
Note: For your safety, this tool is equipped with a double
switching system. This system prevents starting the tool
inadvertently and will only allow operation while holding the
tool with both hands.
To Next Page
Loading...
Need help?
General
