Hold power tool by insulated gripping surfaces when performing an operation where the cutting accessory may
contact hidden Accessory contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the
operator an electric shock.
Use clamps or another practical way to secure and support the work piece to a stable Holding the work by hand or
against your body leaves it unstable and may lead to loss of control.
Vibration
The declared vibration emission values stated in the technical data and the declaration of conformity have been measured in
accordance with a standard test method provided by EN 60745 and may be used for comparing one tool with another. The declared
vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of the power tool can differ from the declared value depending on the
ways in which the tool is used. The vibration level may increase above the level stated. When assessing vibration exposure to
determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of
vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of
the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must read the instruction manual.
Electrical safety
This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage
on the rating plate.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorized Black & Decker Service Centre in
order to avoid a hazard.
Using an extension cable
Always use an approved extension cable suitable for the power input of this tool (see technical data). Before use, inspect the
extension cable for signs of damage, wear and ageing. Replace the extension cable if damaged or defective. When using a
cable reel, always unwind the cable completely. Use of an extension cable not suitable for the power input of the tool or which
is damaged or defective may result in a risk of fire and electric shock.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Dust collection canister
3. Sanding base
4. Finger attachment
Accessories
The accessories supplied with your sander depend upon the model that you have purchased. All the accessories listed below are
available in our Piranha® range. If you require an accessory that is listed below but is not supplied with your sander please visit our
website at www.blackanddecker.eu. The performance of your tool depends on the accessory used. Black & Decker and Piranha
accessories are engineered to high quality standards and designed to enhance the performance of your tool. By using these
accessories you will get the very best from your tool.
Item Description
To Next Page
Loading...
Need help?
General
