Black+Decker KS501 - Safety of Others; Vibration; Labels on Tools; Features

7
ENGLISH
(Original instructions)
• When cutting pipe or conduit, make sure
that they are free from water, electrical
wiring, etc.
• Do not touch the workpiece or the blade
immediately after operating the tool.
They can become very hot.
• Be aware of hidden hazards, before
cutting into walls, floors or ceilings,
check for the location of wiring and
pipes.
• The blade will continue to move after
releasing the switch. Always switch the
tool o and wait for the saw blade to
come to a complete standstill before
putting the tool down.
Warning! Contact with, or inhalation of
dusts arising from cutting applications may
endanger the health of the operator and
possible bystanders. Wear a dust mask
specifically designed for protection against
dust and fumes and ensure that persons
within or entering the work area are also
protected.
• The intended use is described in this
instruction manual.The use of any
accessory or attachment or performance
of any operation with this tool other than
those recommended in this instruction
manual may present a risk of personal
injury and/or damage to property.
Safety of others
• This appliance is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for the their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
Vibration
The declared vibration emission values
stated in the technical data and the
declaration of conformity have been
measured in accordance with a standard
test method provided by EN 60745 and may
be used for comparing one tool with
another. The declared vibration emission
value may also be used in a preliminary
assessment of exposure.
Warning! The vibration emission value
during actual use of the power tool can
dier from the declared value depending on
the ways in which the tool is used. The
vibration level may increase above the level
stated.
When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly
using power tools in employment, an
estimation of vibration exposure should
consider, the actual conditions of use and
the way the tool is used, including taking
account of all parts of the operating cycle
such as the times when the tool is switched
o and when it is running idle in addition to
the trigger time.
Labels on tools
The following symbols are shown on the
tool:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Electrical safety
This tool is double insulated;
therefore no earth wire is required.
Always check that the power
supply corresponds to the voltage
on the rating plate.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the
following features.
1. Variable speed switch (KS701E and
KS701PE) or On/O switch (KS501)
2. Lock-on button
3. Saw blade locking lever