3
remove safety key and disconnect the
battery before touching any parts other
than the handles and switch.
Use common sense. Do not operate
the snow mover when you are tired or if
under the influence of alcohol or drugs.
place and in working order.
WARNING: If the snow mover
strikes any object, follow these steps:
and battery.
2. Inspect for damage.
3. Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting, and any other condition
that may affect its operation.
4. Repair any damage before restarting
and operating the snow mover.
SAVE THESE INSTRUCTIONS
SAFE OPERATION
PRACTICES FOR WALK-
BEHIND SNOW MOVERS
WARNING: This snow mover is
capable of amputating hands and feet
and throwing objects
the following instructions could result in
serious injury.
TRAINING
instructions on the snow mover and in
the instruction manual before operating
this unit. Be thoroughly familiar with
the controls and the proper use of the
and disengage the controls quickly.
the equipment without proper instruction.
persons, particularly small children.
falling, especially when operating the
snow mover in reverse.
PREPARATION
equipment is to be used and remove
all doormats, sleds, boards, wires and
other foreign objects.
wearing adequate winter garments.
Avoid loose fitting clothing that can get
caught in moving parts. Wear footwear
that will improve footing on slippery
surfaces.
while the motor is running.
shields during operation or while
performing an adjustment or repair to
protect eyes from foreign objects that
may be thrown from the snow mover.
OPERATION
discharge opening at all times.
operating on or crossing gravel drives,
hazards or traffic.
motor release bail handle and remove
safety key, thoroughly inspect the snow
thrower for any damage, and repair
the damage before restarting and
operating the snow mover.
abnormally, stop the motor, release
bail handle and remove safety key
and check immediately for the cause.
trouble.
and remove safety key whenever you
leave the operating position, before
unclogging the auger housing or
discharge chute, and when making any
repairs, adjustments or inspections.
the snow mover, stop the motor release
bail handle and remove safety key and
make certain the auger and all moving
parts have stopped.
operating on slopes.
proper guards, and other safety
protective devices in place and working.
people or areas where property
others away.
capacity by attempting to clear snow at
too fast a rate.
transport speeds on slippery surfaces.
operating in reverse.
releasing bail handle, remove safety
key and battery when snow mover is
transported or not in use.
approved by the manufacturer of the
snow mover.
To Next Page
Loading...