INSTALLING AND REMOVING THE
BATTERY PACK
WARNING: Make certain the safety
key is removed to prevent actuation
before removing or installing battery.
TO INSTALL BATTERY PACK:
(24) as shown in Figure 11.
compartment until it is fully seated and
an audible click is heard as shown in
Figure 12. Make sure battery pack
is fully seated and fully latched into
position.
compartment cover.
Ensure the cover is fully latched before
starting snow mover.
TO REMOVE BATTERY PACK:
compartment cover
Depress the battery release button
located on the battery pack and pull
battery pack out of tool as shown in
Figure 13.
9
OPERATION
READ THIS INSTRUCTION MANUAL
BEFORE OPERATING YOUR SNOW
MOVER.“Functional Description”
to familiarize yourself with the location of
this manual for future reference.
WARNING:
work at its own pace. Do not overload.
POWERING ON AND OFF
WARNING:
Open the battery compartment cover
and slide the battery into the battery
compartment until it is fully seated and
an audible click is heard (Fig.12). Make
sure battery pack is fully seated and
fully latched into position.
compartment cover.
Ensure the cover is fully latched before
starting snow mover.
Insert safety key (3) into the key slot
located on the switch housing
until it is fully seated inside housing as
shown in Figure 14. The snow mover is
now operational.
This snow mover is equipped with a
special on-off switch box. To operate
the snow mover, push the safety switch
the handle bar as shown in Figure 15.
To turn the snow mover off, simply release
13
11
24
12
25
15
4
27
2
14
3
26
To Next Page
Loading...