8 • ENGLISH
require any maintenance apart from regular cleaning.
Warning! Before performing any maintenance on the
tool, remove the battery from the tool. Unplug the charger
before cleaning it.
f Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
f Regularly clean the motor housing using a damp
cloth. Do not use any abrasive or solvent-based cleaner.
f Regularly open the chuck and tap it to remove any
dust from the interior.
¡Important! To ensure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those listed in this
manual) should be performed by authorized service centers or other
qualified organizations, always using identical replacement parts.
Unit contains no user service able parts inside.
ACCESSORIES
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Warning! The use of any accessory not recommended
for use with this tool could be hazardous.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be disposed
of with normal household waste.
Should you find one day that your BLACK+DECKER
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
BATTERIES
BLACK+DECKER batteries can be recharged
many times. At the end of their useful life, discard
batteries with due care for our environment:
f Run the battery down completely, then remove it from
the tool.
f NiCd, NiMH and Li-Ion batteries are recyclable.
Take them to any authorized repair agent or a local
recycling station.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Unit will not start. Battery pack not installed properly Check battery pack installation.
Battery pack not charged. Check battery pack charging
requirements.
Battery packwill not charge. Battery pack not inserted into charger. Insert battery pack into charger until
green LED appears
Charger not plugged in. Plug charger into aworking outlet.
Refer to “Important Charging Notes”
formore details.
Unit shuts off abruptly. Surrounding air temperature too hot
or too cold.
Move charger and battery pack to
a surrounding air temperature of
above 40 oF 4,5°C) or below 105 oF
(+40,5°C).
Battery pack has reached its
maximumthermal limit.
Allow battery pack to cool down.
Out of charge. (To maximize the life
of the battery pack it is designed to
shut off abruptly when the charge is
depleted.)
Place on charger and allow to charge.
To Next Page
Loading...
