6
(Original instructions)
u Thoroughly remove all dust after sanding.
u Take special care when sanding paint which
is possibly lead based or when sanding some
woods and metal which may produce toxic
dust:
t Do not let children or pregnant women enter
the work area.
t Do not eat, drink or smoke in the work area.
t Dispose of dust particles and any other
debris safely.
u The intended use is described in this instruc-
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
u The accessory will continue to move after
releasing the switch. Always switch the tool off
and wait for the accessory to come to a com-
plete standstill before putting the tool down.
u Keep hands away from cutting area. Never
reach underneath the work piece for any
reason. Do not insert ngers or thumb into the
vicinity of the reciprocating blade and blade
clamp. Do not stabilize the saw by gripping the
shoe.
u Keep blades sharp. Dull or damaged blades
may cause the saw to swerve or stall under
pressure. Always use the appropriate type of
saw blade for the workpiece material and type
of cut.
u When cutting pipe or conduit, make sure that
they are free from water, electrical wiring, etc.
u Do not touch the workpiece or the blade
immediately after operating the tool. They can
become very hot.
u Be aware of hidden hazards, before cutting into
walls, oors or ceilings, check for the location
of wiring and pipes.
Features (g. A)
Tool shown is MT143. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
10. Super-lok
TM
Tool free accessory clamping lever
Accessories
This tool includes some or all of the following
accessories.
To Next Page
Loading...
Need help?
General
