Blackshape Prime - 5.1. Introduction; 5.2. Performance Tables and Diagrams; 5.2.1. Airspeed System Calibration; 5.2.2. Cruising Performance

CF 300 – Flight Manual sect. 5 - Performance
BY BLACKSHAPE
Document n° BPU/FM003
Rev 3 dtd 03/06/2014 Page 51
-66
5.1. INTRODUCTION
Section 5 contains all the data necessary for complete and accurate flight planning, from take-off to landing.
The data given in tables and diagrams have been determined using the following parameters:
· Aircraft and engine in flying conditions
· Normal flight procedures and piloting techniques
· Wind speed
· Outside air temperature
· QFE altitude
· QNH atmospheric pressure at sea level
· Weight
The diagrams and tables are determined in accordance with ICAO standard atmosphere (ISA - m.s.l).
5.2. PERFORMANCE TABLES AND DI AGRAMS
5.2.
1 Airspeed System Calibration
Airspeed calibration might be subject to changes due to operational use. An airspeed calibration check is
recommended each 6 months and is scheduled at each annual inspection.
5.2.2. Cruising performance
Maximum power RPM is 5500.
Figure 5.
1 – Cruising performance
UNCONTROLLED