Blade Red Bull BO-105 CB 130 X User Manual (English)

Questions and Answers:

K
Kimberly RubioAug 1, 2025
What to do if the LED flashes rapidly and my Blade Toy helicopter won't respond after binding?
- K
  kim34Aug 1, 2025
  If the LED on the receiver of your Blade helicopter flashes rapidly and the aircraft doesn't respond to the transmitter after binding, there might be several reasons: * Less than a 5-second wait between powering on the transmitter and connecting the flight battery. To solve this, leave the transmitter powered on, then disconnect and reconnect the flight battery to your helicopter. * The helicopter is bound to a different model memory (ModelMatch™ transmitters only). Select the correct model memory on the transmitter and reconnect the flight battery. * The flight battery or transmitter battery charge is too low. Replace or recharge the batteries. * The flybarless unit has not initialized yet. Wait for the unit to initialize.
L
Lori GrayAug 6, 2025
Why won't my Blade Red Bull BO-105 CB 130 X Toy helicopter respond to the throttle?
- R
  Robert HillAug 6, 2025
  If your Blade Toy helicopter won't respond to throttle, it could be due to a few reasons: * The throttle is too high or the throttle trim is too high. Reset the controls with the throttle stick and throttle trim at the lowest setting. * The helicopter moved during initialization. Disconnect the flight battery and re-initialize your helicopter while keeping it still. * The throttle channel is reversed. Disconnect the flight battery, reverse the throttle channel on the transmitter, and reconnect the flight battery.
S
stephanie81Aug 13, 2025
Why is there tail vibration during spool up on my Blade Toy helicopter?
- S
  Samantha AndersonAug 13, 2025
  Tail vibration during spool up in your Blade helicopter can occur because the RPM of the main and tail systems reach a point of resonance during spool up. Quickly move through this head speed range by advancing the throttle from low to about 75% immediately. If the vibration persists at flight RPM, the tail output shaft might be bent, and you should replace it.
C
Crystal SummersAug 26, 2025
What to do if Blade Red Bull BO-105 CB 130 X Toy helicopter smells burnt and doesn't function after connecting the battery?
- J
  Joseph PotterAug 26, 2025
  If your Blade Toy helicopter doesn't function and smells burnt after connecting the flight battery, it's likely that the flight battery was connected with the wrong polarity. Replace the 3-in-1 board and ensure you connect the flight battery with the correct polarity.