REQUIRED TREADMILL LUBRICATION
The running belt can shift to one side or simply
‘skid over’ when running. To center the belt using
the 6mm Allen wrench, run the machine at 3mph
for a few minutes to determine which side the belt
is drifting towards; left or right.
If the belt is drifting left
i) Turn the treadmill off and unplug from the
machine.
ii) Tighten the left bolt a ¼ turn (clockwise).
iii) Loosen the right bolt a ¼ turn (counterclockwise).
iv) Run the belt at 3 mph again for a few minutes.
If the belt continues to drift to the left, repeat
steps.
If the belt is drifting right
i) Turn the treadmill off and unplug from the
machine.
ii) Tighten the right bolt a ¼ turn (clockwise).
iii) Loosen the left bolt a ¼ turn
(counterclockwise).
iv) Run the belt at 3 mph again for a few minutes.
If the belt continues to drift to the right, repeat
steps.
Once the running belt has been adjusted closer
to the center, the treadmill can be powered on
again.
Use 6mm Allen wrench to loosen the bolts in the
end caps. Remove excessive accumulations of dust,
dirt, and other substances from running deck. Use a
clean soft cloth.
Do not use cleaner under the running
belt.
Pull up running belt, dispense lubricant on
deck, and spread evenly.
After lubricating deck, center the belt, and tighten
the end caps. Check belt condition and adjust if
necessary referring to the steps above.
Rear Roller Bolt
6 mm wrench
0.5~4.0 Miles/day lubricate every 1 year
4.0~7.0 Miles/day lubricate every 6 months
7.0~10.0 Miles/day lubricate every 3 months
IMPORTANT!
Silicone lubricant is designed to reduce friction
between the treadmill belt and deck.
Proper and timely application of Silicone
lubricant will prevent excessive static
electricity build-up which can result in
electrical component failure in the unit’s
console and/or mechanical failure due to
excessive wear and tear.
Warning!
It is required that the deck be lubricated
before first use and regularly thereafter according
to the frequency of use (see table below).
Suggested lubrication based on usage below:
If running at speed:
3
To Next Page
Loading...
