Why does my BLADEZ E-LITE 250 Scooter E-Lite ‘sputter’ or accelerate very slowly?
If your BLADEZ Scooter E-Lite sputters or accelerates slowly, the battery is likely running out of charge. Recharge your E-Lite to resolve this issue.
What to do if the BLADEZ E-LITE 250 Scooter charger is plugged in, but the light keeps blinking red?
If the BLADEZ Scooter charger light keeps blinking red, it means your E-Lite has gone into deep discharge and cannot identify the charge status. Leave the charger plugged in for 60 minutes. When the charger recognizes a charge, the charger light will turn solid.
Why does my BLADEZ E-LITE 250 E-Lite not hold the charge long enough?
If your BLADEZ Scooter E-Lite does not hold a charge for very long, the sealed Lead Acid batteries have likely reached the end of their life and need to be replaced. Please call Bladez for Replacement Information.
How to fix a BLADEZ Scooter when the charger light turns green right away?
If the charger light on your BLADEZ scooter turns green immediately, charge your scooter for an additional 6-8 hours prior to initial use.
Describes initial setup steps before the first ride.
Explains how to access components using the deck release.
Details the battery pack and its connection.
Instructions on how to charge the scooter.
Step-by-step guide to unfold the power board.
Instructions on how to operate and ride the power board.
Explains the LED indicators for battery status.
Lists necessary tools for adjustments and servicing.
Details the rear wheel drum brake operation and maintenance.
Information on tire inflation and wheel assembly.
Guidance on keeping the chain properly lubricated.
Instructions for adjusting chain tension.
To Next Page
General
