What to do if my BLADEZ Scooter will not move?
If your BLADEZ Scooter doesn't move when you activate the throttle lever, it could be due to a loose throttle cable. Try tightening the cable. Also, check if the batteries are fully charged and charge them if necessary. If the problem persists, the batteries may have reached the end of their life and need replacement.
Why won't my BLADEZ XTR-HD batteries hold a charge?
If the batteries of your BLADEZ Scooter aren't holding a charge or the scooter isn't reaching its specified travel range, the batteries may be at the end of their life and need to be replaced. Another possible cause is a malfunctioning charger, which would also need to be replaced.
How to fix a BLADEZ XTR-HD that moves slowly?
If your BLADEZ Scooter moves intermittently or very slowly, ensure the batteries are fully charged. If they aren't, charge them. Another possibility is a loose throttle cable; in that case, you should tighten the cable.
What to do if my BLADEZ Scooter stops suddenly?
If your BLADEZ Scooter stops abruptly during use, it's possible that the circuit breaker has tripped. To resolve this, allow the electric motor to cool down, then reset the circuit breaker by turning the power switch off and on.
Steps to attach and secure the handlebar for the Bladez Power Board.
Guide on how to unfold the Bladez Power Board from its folded position.
Instructions on how to operate and ride the Bladez Power Board safely.
To Next Page
General
