Locating your Inpond All-in-One
The Inpond pump and filter should be located on a firm and level base in the
pond/water feature in a depth of at least 10cm, but no more than 1.25m.
It is advisable to keep the pump off the bottom of the pond to avoid silt
entering the pump causing excessive wear and increasing pre-filter cleaning.
Fountain
Make sure there is ample cable from mains supply. Place filter in desired
location. Add Fountain extension pipes so fountain head is above surface of
the pond. Fountain height can now be adjusted, see ‘Adjusting flow control’
diagram below. See "Getting to know your Inpond" for parts and descriptions.
The flow control valve is fitted with a diverter to ensure there is always pond
circulation.
Tip: Ensure that any fountain or feature fitted does not empty water out of
pond/water feature.
Water Feature
Install as for Fountain. Depending on water feature to be supplied, your
Inpond All-in-One can be used with the flow control and the
1
/
2
" hose fitting.
Hose clips should be used to secure hose. See page 8, fitting a waterfall or
feature.
INSTALLATION
BELL FOUNTAIN
Adjust bell by
moving head higher
for small bell and
lower for a wider
bell shape.
ADJUSTING FLOW CONTROL
Turn clockwise to increase anti-clockwise
to reduce flow.
6 7
INSTALLATION
CONVENIENT INSTALLATION
The Inpond All-in-One can be installed either powering a waterfall or
fountain.
Inpond Filter Inpond Filter
Waterfall or feature option Fountain option
WATERFALL OR FEATURE
HOSE
FOUNTAIN
MAX 70cm
MIN 40cm
TYPICAL INSTALLATION
To Next Page
Loading...